Programming the ADS-FX2 solenoid controller with JMRI

It is possible to program the ADS-FX2 solenoid controller with JRMI with the following procedure:

1. Open PanelPro
2. Open Power Control (Tools > Power Control)
3. Ensure the power to the track is on
4. Open Tools > Tables > Turnouts
5. Add the IDs of the turnouts that you wish to program (Click Add, then enter the hardware address and save)
6. Open a throttle (Tools > Throttles > New Throttle)
7 Set the switch on the ADS-FX2 for the desired solenoid to Program
8. In the throttle window enter the desired address into the address panel and press Set
9. Go to the Turnouts table window and Issue the Thrown / Closed command against the matching address that you entered in the earlier step
10. Set the switch on the ADS-FX2 back to Run
11. Try throwing the points using the Turnout table window